AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE) > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
DTCs which are stored in the ECM can be displayed with the intelligent tester or generic OBD II scan tool.
These scan tools can display pending DTCs and current DTCs. Some DTC aren't stored if the ECM doesn't detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as pending DTC.
Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3).
Turn the ignition switch to the ON position.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES (or PENDING CODE).
Confirm the DTCs and freeze frame data and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC |
Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
Turn the ignition switch to the ON position.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CLEAR CODES and press YES.