AUTOMATIC TRANSMISSION SYSTEM (for 2UZ-FE) > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF (Automatic Transmission Fluid).
Turn the ignition switch off.
Lift the vehicle up.
Remove the test plug on the transmission case center right side and connect SST.
Lower the vehicle.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check idling speed.
Keep your left foot pressing firmly on the brake pedal and shift into D position.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.
In the same manner, do the test in R position.
| Condition | D position kPa (kgf/cm2, psi) | R position kPa (kgf/cm2, psi) |
| Idling | 362 to 420 kPa (3.7 to 4.2 kgf/cm2, 53 to 59 psi) | 500 to 580 kPa (5.1 to 5.9 kgf/cm2, 73 to 84 psi) |
| Stall test | 1,360 to 1,460 kPa (13.8 to 14.9 kgf/cm2, 196 to 212 psi) | 1,295 to 1,415 kPa (13.2 to 14.4 kgf/cm2, 188 to 205 psi) |
| Problem | Possible cause |
| If the measured values at all position are higher |
|
| If the measured values at all position are lower |
|
| If pressure is low in the D position only |
|
| If pressure is low in the R position only |
|