DTC P0717 Turbine Speed Sensor Circuit No Signal |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 | All conditions below are detected for 5 secs. or more (1-trip detection logic) (a) Gear change is not performed (b) Gear position: 4th or 5th (c) T/M input shaft rpm: 300 rpm or less (d) T/M output shaft rpm: 1,000 rpm or more (e) Park/neutral position switch:
|
|

| Terminal | NT+ - NT- |
| Tool setting | 1 V/DIV, 2 ms./DIV. |
| Vehicle condition | Engine idle speed (P or N position) |
| Related DTCs | P0717: Speed sensor (NT)/Verify pulse input |
| Required sensors/Components (Main) | Speed sensor (NT) |
| Required sensors/Components (Related) | Speed sensor (NC) |
| Frequency of operation | Continuous |
| Duration | 5 sec. |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | P0500 (VSS) P0748 (Trans solenoid (range)) |
| Shift change | Shift change is completed and before starting next shift change operation |
| ECM selected gear | 4th or 6th |
| Output shaft rpm | 1,000 rpm or more |
| NSW (STAR) switch | OFF |
| R switch | OFF |
| L switch | OFF |
| Engine | Running |
| Ignition switch | ON |
| Starter | OFF |
| Sensor signal rpm | Less than 300 rpm |
| Speed sensor (NT) | Input speed is equal to engine speed when lock-up ON. |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "DIAGNOSIS / OBD/MOBD / ECT / DATA LIST".
According to the display on the tester, read the "DATA LIST".
| Item | Measurement Item/Range (display) | Normal Condition |
| SPD (NT) | Input Turbine Speed/display: 50 r/min |
|
| 1.INSPECT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor (NT) installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NT) |
![]() |
Disconnect the speed sensor connector from the transmission.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| 1 - 2 | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| E5-35 (NT+) - E5-27 (NT-) | 560 to 680 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E5-35 (NT+) - Body ground | 10 kΩ or higher |
| E5-27 (NT-) - Body ground | ↑ |
|
| ||||
| OK | ||
| ||