DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | Both (a) and (b) are detected: (2-trip detection logic) (a) Intake air and engine coolant temps. are more than -10°C (14°F) at engine start (b) After normal driving for over 22 min. and 9 km (6 mile) or more, ATF temp. is less than 20°C (68°F) | Transmission wire (ATF temperature sensor No. 1) |
| Related DTCs | P0711: ATF temperature sensor/Rationality check |
| Required sensors/Components | ATF temperature sensor (TFT sensor) |
| Frequency of operation | Continuous |
| Duration | 3 sec. |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | None |
| TFT sensor circuit | Not circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | Not circuit malfunction |
| IAT (Intake air temperature) sensor circuit | Not circuit malfunction |
| Time after engine start | 21 min. and 40 sec. |
| Driving distance after engine start | 5.6 mile (9 km) or more |
| IAT (12 sec. after engine start) | -10°C (14°F) or more |
| ECT (12 sec. after engine start) | -10°C (14°F) or more |
| TFT (Transmission fluid temperature) | Less than 20°C (60°F) (ATF temperature = -10°C (14°F) at engine start) (Conditions vary with ATF temperature at engine start) |
| TFT | Atmospheric temperature - approx. 130°C (266°F) |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "DIAGNOSIS / OBD/MOBD / ECT / DATA LIST".
According to the display on the tester, read the "DATA LIST".
| Item | Measurement Item/Range (display) | Normal Condition |
| AT FLUID TEMP | ATF Temp. Sensor Value/min.: -40°C (-40°F) max.: 215°C (419°F) |
|
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the OBD II scan tool or the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and push the OBD II scan tool or the intelligent tester main switch ON.
When you use intelligent tester:
Select the item "DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES".
Read the DTCs using the OBD II scan tool or the intelligent tester.
| Display (DTC output) | Proceed to |
| Only "P0711" is output | A |
| "P0711" and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
|
| ||||
| OK | ||
| ||