Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

MULTIPLEX COMMUNICATION SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (BODY ECU)


  1. Disconnect the 1B, 1E, 1F, 1H and 1L J/B connectors.


    B065658E01

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    BECU (1F-12) - Body ground
    W-R - Body ground
    Power source (+B)
    Always
    10 to 14 V
    BECU (1B-4) - Body ground
    W-R - Body ground
    Power source (+B)
    Always
    10 to 14 V
    BECU (1L-4) - Body ground
    W-R - Body ground
    Power source (+B)
    Always
    10 to 14 V
    BDR1 (1E-9) - Body ground
    G-W - Body ground
    Power source (+B)
    Always
    10 to 14 V
    GND1 (1H-2) - Body ground
    W-B - Body ground
    Ground for main power supply
    Always
    Below 1 Ω
    GND2 (1H-2) - Body ground
    W-B - Body ground
    Ground for main power supply
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.


CHECK THEFT WARNING ECU ASSEMBLY (THEFT DETERRENT ECU)


  1. Disconnect the T5 connector.


    B050657E08

  2. Measure the voltage and resistance of the wire harness side connectors.

    Symbols (Terminals No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    +B1 (T5-2) - Body ground
    W-R - Body ground
    Power source (+B)
    Always
    10 to 14 V
    +B2 (T5-3) - Body ground
    W-L - Body ground
    Power source (+B)
    Always
    10 to 14 V
    E (T5-29) - Body ground
    W-B - Body ground
    Ground for main power supply
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.


CHECK MULTIPLEX NETWORK DOOR ECU BACK (BACK DOOR ECU)


  1. Disconnect the B8 connector.


    B062706E05

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminals No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    BDR (B8-4)- Body ground
    L - Body ground
    Power source (+B)
    Always
    10 to 14 V
    BECU (B8-5) - Body ground
    L-R - Body ground
    Power source (+B)
    Always
    10 to 14 V
    GND (B8-3) - Body ground
    W-B - Body ground
    Ground for main power supply
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.