MULTIPLEX COMMUNICATION SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
The network gateway ECU controls the functions of the multiplex communication system on the vehicle. Data of the multiplex communication system and the Diagnostic Trouble Codes (DTC) can be read through the Data Link Connector 3 (DLC3) of the vehicle.
| CHECK DLC3 |
![]() |
The vehicle's ECU uses the ISO 1565-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAEJ 1962 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| MULTIPLEX COMMUNICATION SYSTEM (BEAN) |
The BEAN communication line consists of 2 systems:
One is a system with a loop-shaped line that the back door ECU is united with the body ECU present in the center of the line. Another is a system that the body ECU and the theft deterrent ECU are connected alone.
Since the line for the back door ECU is loop-shaped, the communication can be maintained by the line that is not open even if part of the line become open for some reason. In the case that there is a short-circuit (bus-down) in the line, however, all the BEAN communication becomes impossible in the system and some DTCs are output.
| COMMUNICATION FUNCTION INSPECTION |
Inspect the battery voltage.
Inspect the diagnosis monitor code output.
Check a diagnosis code for the body ECU by connecting the intelligent tester to the DLC3 and turning the ignition switch ON.
When the display shows diagnostic codes of the ECU unconnected and the communication bus defective, perform the inspection depending on the troubleshooting.