Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > SRS Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

Click here.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

1.CHECK BATTERY
  1. Measure the voltage of the battery.

    Standard voltage:
    11 to 14 V



NG
CHECK AND REPLACE BATTERY OR CHARGING SYSTEM
OK


2.CHECK CONNECTOR
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Check that the connector is properly connected to the combination meter assembly.

    OK:
    The connector is properly connected.



NG
CONNECT CONNECTOR
OK


3.CHECK WIRE HARNESS (SOURCE VOLTAGE OF COMBINATION METER)


    I033110E03
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Remove the combination meter assembly (Click here).

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage::
    Tester connection
    Condition
    Specified condition
    C10-15 - Body ground
    Ignition switch ON
    10 to 14 V

  1. Turn the ignition switch to the LOCK position.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance::
    Tester connection
    Condition
    Specified condition
    C10-13 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS
OK


4.CHECK SRS WARNING LIGHT
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Connect the connector to the combination meter assembly.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to the ON position.

  1. Check the SRS warning light condition.

    OK:
    After the primary check period, SRS warning light goes off for approximately 10 seconds, and remains on.

    HINT:
    The primary check period is approximately 6 seconds after the ignition switch is turned to the ON position.



NG
GO TO COMBINATION METER SYSTEM
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY