Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0571    Brake Switch "A" Circuit

for Preparation Click here


DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the ECM. When the ECM receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. The cancellation condition occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the ECM through the STOP SW fuse and the stop light switch, and the ECM turns the cruise control off.

DTC No.
DTC Detection Condition
Trouble Area
P0571
Stop light switch assembly does not turn off even once the vehicle is driven.
  1. Stop light switch
  2. Stop light switch circuit
  3. ECM

WIRING DIAGRAM


E116138E01


INSPECTION PROCEDURE

1.CHECK STOP LIGHT SWITCH OPERATION
  1. Check that the stop light lights up when brake pedal is depress and turns OFF when the brake pedal is released.



NG
INSPECT STOP LIGHT SWITCH CIRCUIT
OK


2.INSPECT STOP LIGHT SWITCH


    E065594E51
  1. Remove stop light switch .

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    10 kΩ or higher
    3 - 4
    Switch pin not pushed
    Below 1 Ω
    1 - 2
    Switch pin pushed
    Below 1 Ω
    3 - 4
    Switch pin pushed
    10 kΩ or higher

  1. Install the stop light switch.



NG
REPLACE STOP LIGHT SWITCH
OK


3.CHECK ECM


    A131509E68
  1. Reconnect the stop light switch connector.

  1. Remove the ECM with connectors still connected.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Brake Pedal Condition
    Specified Condition
    E8-15 (STP) - Body ground
    Depressed
    10 to 14 V
    E8-15 (STP) - Body ground
    Released
    Below 1 V
    E8-16 (ST1-) - Body ground
    Depressed
    Below 1 V
    E8-16 (ST1-) - Body ground
    Released
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH - ECM)
OK

REPLACE ECM