PARK / NEUTRAL POSITION SWITCH > ADJUSTMENT |
| 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Apply the parking brake and turn the ignition switch ON.
Depress the brake pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.
Check that the back-up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function in other positions.
If a failure is found, check the park/neutral position switch for continuity.
| 2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Loosen the park/neutral position switch bolt and move the shift lever to N.
Align the switch groove with the neutral basic line.
Hold the switch in position and tighten the bolt.