Home › BRAKE › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > INSTALLATION

for Preparation Click here



1. INSTALL PARKING BRAKE CABLE ASSEMBLY NO. 3


    D028123
  1. Install the parking brake cable assembly no. 3 with the clip to the parking brake equalizer.



  1. Install the parking brake cable assembly No. 3 with the 4 bolts.


    D028122

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



    D028121
  1. Install the parking brake cable assembly No. 3 with the 2 bolts to the backing plate.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



2. APPLY HIGH TEMPERATURE GREASE
  1. Apply the high temperature grease to the shoe attached surface of backing plate (Click here).



3. INSTALL PARKING BRAKE SHOE
  1. Install the shoe lever and the shim to the rear shoe with a new C-washer.



    R000343
  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    Less than 0.25 mm (0.0098 in.)

    If the clearance is not within the specification, replace the shim with one of the correct size.
    Shim Thickness
    Shim Thickness
    0.3 mm (0.012 in.)
    0.6 mm (0.024 in. )
    0.4 mm (0.016 in.)
    0.9 mm (0.035 in.)
    0.5 mm (0.020 in.)
    -



    F041705
  1. Apply the high temperature grease to the adjusting bolt and piece.

  1. Install the shoe adjusting screw set and the tension spring to the front and rear shoe.

  1. Install the 2 pins, 4 cups and 2 shoe hold-down springs.

  1. Connect the parking brake cable to the shoe lever.

  1. Install the front and rear parking brake shoe.



4. INSTALL PARKING BRAKE SHOE STRUT LH


5. INSTALL PARKING BRAKE SHOE STRUT COMPRESSION SPRING


6. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING
  1. Using a needle nose pliers, install the 2 return tension springs.

    HINT:
    Install front side spring first, rear side spring next.



7. CHECK PARKING BRAKE INSTALLATION


  1. Check that each part is installed properly.

    NOTICE:
    There should be no oil or grease adhering to the friction surface of the shoe lining and disk.



    D028130E02



8. INSTALL REAR DISC


9. ADJUST PARKING BRAKE SHOE CLEARANCE


    D028131E02
  1. Temporarily install the hub nuts.

  1. Remove the hole plug, and turn the adjuster and expand the shoes until the disc locks.

  1. Contract the shoe adjuster until the disc rotates smoothly.

    Standard :
    Return 8 notches

  1. Check the shoe has no brake drag.

  1. Install the hoke plug.



10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Install the rear disc brake caliper assembly LH with the 2 bolts.

    Torque:
    105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



11. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 83 ft.*lbf }



12. INSTALL CONSOLE BOX ASSEMBLY REAR


13. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER


14. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


15. INSPECT PARKING BRAKE PEDAL TRAVEL

HINT:
(Click here)



16. ADJUST PARKING BRAKE PEDAL TRAVEL

HINT:
(Click here)