Home › BRAKE › PARKING BRAKE › PARKING BRAKE ASSEMBLY

PARKING BRAKE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT BRAKE DISC INSIDE DIAMETER


    F006409
  1. Using a brake drum gauge or equivalent, measure the inside diameter of the disk.

    Standard inside diameter:
    210mm (8.27 in.)

    Maximum inside diameter:
    211mm (8.30 in.)



2. INSPECT PARKING BRAKE SHOE LINING THICKNESS


    BR05332
  1. Using a ruler, measure the thickness of the shoe lining.

    Standard inside diameter:
    4.0mm (0.158 in.)

    Maximum inside diameter:
    1.0mm (0.039 in.)

    If the lining thickness is at the minimum thickness or less, or if there is severe or uneven wear, replace the brake shoe.



3. INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT


    BR00828
  1. Apply chalk to the inside surface of the disc, then grind down the brake shoe lining to fit.
    If the contact between the brake disc and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.