Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH

NOTICE:
Do not disassemble the retractor.



    B065022E01
  1. Check the degree of tilt when beginning to lock the ELR.

    1. Check that the belt does not lock within 15° of tilt in all the direction but the belt locks over 45° of tilt, when moving the installed retractor gently.
      If operation is not as specified, replace the outer belt assembly.

  1. Install the retractor with the 2 bolts.

    Torque:
    For upper bolt:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
    For lower bolt:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the shoulder anchor with the nut.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the center pillar garnish upper RH.

  1. Install the center pillar garnish lower RH.

  1. Install the floor anchor with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the floor anchor cover.

  1. Check the ELR lock.

    NOTICE:
    The check should be performed with the outer belt assembly installed.


    1. Check that the belt locks when pulling out the belt quickly with the belt installed.
      If operation is not as specified, replace the outer belt assembly.



2. INSTALL CENTER PILLAR GARNISH UPPER RH


3. INSTALL CENTER PILLAR GARNISH LOWER RH


4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH


6. INSTALL REAR DOOR SCUFF PLATE RH


7. INSTALL FRONT DOOR SCUFF PLATE RH


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL