Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL J/B ASSEMBLY (BODY ECU)


  1. Disconnect the B6 ECU connector and 1F, 1E, 1B, 1L and 1H J/B connectors.


    B064139E01

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Symbols
    (Terminal No.)
    Wiring Color
    Condition
    Specified Condition
    BECU (1F-12) - Body ground
    W-R - Body ground
    Always
    10 to 14 V
    BECU (1B-4) - Body ground
    W-R - Body ground
    Always
    10 to 14 V
    BECU (1L-4) - Body ground
    W-R - Body ground
    Always
    10 to 14 V
    BDR1 (1E-9) - Body ground
    G-W - Body ground
    Always
    10 to 14 V
    GND1 (1H-2) - Body ground
    W-B - Body ground
    Always
    Below 1 Ω
    GND2 (1H-2) - Body ground
    W-B - Body ground
    Always
    Below 1 Ω
    KSW (B6-14) - Body ground
    G-Y - Body ground
    No key in ignition key cylinder → Key inserted
    10 kΩ or higher → Below 1 Ω

    HINT:
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the B6 connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Symbols
    (Terminal No.)
    Wiring Color
    Condition
    Specified Condition
    DCTY (B5-23) - Body ground
    R-B - Body ground
    Driver door
    CLOSED → OPEN
    10 to 14 → 0 V