Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE HEADLIGHT NO. 1 BULB


    E116241
  1. Remove the headlight No. 1 bulb as shown in the illustration.



2. REMOVE HEADLIGHT NO. 2 BULB


    E116121
  1. Remove the headlight No. 2 bulb as shown in the illustration.



3. REMOVE FRONT TURN SIGNAL LIGHT BULB


    E116122
  1. Remove the front turn signal light bulb as shown in the illustration.



4. REMOVE CLEARANCE LIGHT BULB


    E116123
  1. Remove the clearance light bulb as shown in the illustration.

    HINT:
    1. Since the low-beam light and the high-beam light are a unit, if the aim on one is correct, the other should also be correct. However, check both beams just to make sure.
    2. Alignment distance is 7.62 m (25 ft):
      The cutoff line is 101 mm (3.97 in.) above and below the H line as well as left and right of the V line with low-beam (SAE J599).
    3. Alignment distance is 3 m (9.84 ft):
      The cutoff line is 40 mm (1.57 in.) above and below the H line as well as left and right of the V line with low-beam (SAE J599).
    4. Alignment distance is 7.62 m (25 ft):
      The cutoff line is 101 mm (3.97 in.) above and below the H line as well as left and right of the V line with high-beam (SAE J599).
    5. Alignment distance is 3 m (9.84 ft):
      The cutoff line is 40 mm (1.57 in.) above and below the H line as well as left and right of the V line with high-beam (SAE J599).
    6. Alignment distance is 7.62 m (25 ft):
      The cutoff line is 53 mm (2.08 in.) below the H line with low-beam.
    7. Alignment distance is 3 m (9.84 ft):
      The cutoff line is 21 mm (0.82 in.) below the H line with low-beam.