Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Troubleshoot in accordance with the procedures on the following pages.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.DTC CHECK
      1. Check for DTCs and make a note of the code that is output.

      2. Delete the DTC.

        HINT:
        Click here

      3. Check if the DTC will be output once again when the problem symptom is simulated based on the noted code.

        1. With an output of the code, proceed to A.

        2. Without an output of the code, proceed to B.



      A.
      GO TO STEP 5
      B


      4.PROBLEM SYMPTOMS TABLE

        HINT:
        Click here


      NEXT


      5.PERFORM TROUBLESHOOTING
      1. Operation check.

        HINT:
        Click here

      2. Circuit inspection.


      NEXT


      6.ADJUST, REPAIR OR REPLACE

        NEXT


        7.RESET POWER WINDOW REGULATOR MOTOR
        1. If any of the power window switch illuminations is blinking after repair, reset the power window.

          1. Turn the ignition switch ON.

          2. Open the driver side door glass.

          3. Fully pull up the AUTO switch of the power window master switch until the door glass is fully closed.

          4. Check that the AUTO UP/DOWN function operates normally.


        NEXT

        END