DTC B2784 Antenna Coil Open / Short |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2784 | Antenna coil open/short |
|

| 1.READ VALUE OF INTELLIGENT TESTER |
Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select ANTENNA COIL in the DATA LIST and read the value displayed on the intelligent tester.
| Item | Measurement Item/Display (Range) | Normal Condition | Diagnostic Note |
| ANTENNA COIL | Antenna coil condition /NORMAL or FAIL | NORMAL: Antenna coil is normal. FAIL: Antenna coil is malfunctioning. | - |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY AMPLIFIER) |
![]() |
Disconnect the T8 ECU and I17 switch connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| T8-8 (VC5) - I17-1 (VC5) | Below 1 Ω |
| T8-11 (CODE) - I17-4 (CODE) | |
| T8-12 (TXCT) - I17-5 (TXCT) | |
| T8-13 (AGND) - I17-7 (GND) | |
| T8-8 (VC5) - Body ground | 10 kΩ or higher |
| T8-11 (CODE) - Body ground | |
| T8-12 (TXCT) - Body ground | |
| T8-13 (AGND) - Body ground |
|
| ||||
| OK | |
| 3.INSPECT TRANSPONDER KEY ECU ASSEMBLY |
![]() |
Reconnect the T8 ECU and I17 amplifier connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T8-8 (VC5) - Body ground | No key is in ignition key cylinder | Below 1 V |
| Key is in ignition key cylinder | 4.6 to 5.4 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T8-13 (AGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||