Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC


    G039021E04
  1. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

  4. Read the DTCs by following the directions on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR THE DTC
  1. Connect the intelligent tester (with CAN VIM) to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

  4. Erase the DTCs by following the directions on the screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.