ENGINE IMMOBILISER SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Read the DATA LIST according to the display on the tester.
| Item | Measurement Item/Display (Range) | Normal Condition | Diagnostic Note |
| KEY SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
| IG SW | Ignition switch signal / ON or OFF | ON: Ignition switch on OFF: Ignition switch off | - |
| IMMOBILISER | Immobiliser system status / SET or UNSET | UNSET: Ignition switch on SET: Without key | - |
| RESPONSE | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| FRAME | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| SERIAL NUMBER | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| ENCRYPT CODE | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| STATUS | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| BCC | Transponder chip data / NG or OK | NG: Incorrect data being sent. OK: Correct data being sent. | - |
| SUB KEY | Sub key code signal / NOMATH or MATCH | NOMATCH: Non matching sub key code is sent. MATCH: Sub key code is sent. | - |
| MASTER KEY | Master key code signal / NOMATH or MATCH | NOMATCH: Non matching master key code is sent. MATCH: Master key code is sent. | - |
| REGIST SUB CODE | Number of registered sub key / min. 0, max. 15 | Number of registered sub key. | - |
| REGIST MAS CODE | Number of registered master key / min. 0, max. 15 | Number of registered master key. | - |
| REG CODE SPAC | Memory space for key codes registration / NOT FUL or FULL | NOT FUL: More key code registration possible. FULL: No more key code registration possible. | - |
| +B | Power source / BRAKE or NORMAL | BRAKE: Power source open. NORMAL: Power source normal. | - |
| ANTENNA COIL | Antenna coil condition / NORMAL or FAIL | NORMAL: Antenna coil is normal. FAIL: Antenna coil is malfunctioning. | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Perform the ACTIVE TEST to the display on the tester.
| Item | Test Details | Diagnostic Note |
| SECURITY INDIC | Turn security indicator ON / OFF | - |