ENGINE IMMOBILISER SYSTEM > REGISTRATION |
| 1. DESCRIPTION OF CODE REGISTRATION |
When adding master keys or sub keys (Additional registration):
Register key code (immobiliser code) in the transponder key ECU.
| Target ECU | See Procedure |
| Transponder key ECU | Procedure "A" |
When replacing the transponder key ECU (New registration):
Register the key code (immobiliser code) in the transponder key ECU.
| Target ECU | See Procedure |
| Transponder key ECU | Procedure "B" |
Register the ECU COMMUNICATION ID between the ECM and the transponder key ECU.
| Target ECU | See Procedure |
| Transponder key ECU | Procedure "C" |
When replacing the ECM:
Register the ECU COMMUNICATION ID between the ECM and the transponder key ECU.
| Target ECU | See Procedure |
| Transponder key ECU | Procedure "C" |
| 2. KEY REGISTRATION |
Automatic registration (Procedure "B"):
The new registration of the key codes (immobiliser codes) is made automatically.
| Procedure | Security Indicator Condition |
| 1. Start (Procedure "D") | Blinking occurs until the first key is inserted. |
| 2. Insert the key into the ignition key cylinder. | ON |
3. Registration begins.
| OFF
|
| 4. Remove the key. | ON
|
| 5. Register another key ? Yes: Go to procedure "D" No: Go to procedure "E" | |
| 6. End (Procedure "E") | |

Finish the automatic key code registration mode. The automatic key code registration mode can be forced to end, when at least 1 key code (immobiliser code) for the master key has been registered.
Turn the ignition switch on and off 5 times within 10 seconds using the already registered master key.
| 3. REGISTRATION OF ADDITIONAL KEY |
Additional registration (Procedure "A"):
Register an additional key by using the intelligent tester.
| Procedure | Time (Completion of operation) | Security Indicator Condition |
| 1. Start | - | Indicator blinks until the first key is inserted. |
| 2. Insert the already registered master-key in the ignition key cylinder and turn the ignition switch on. | ||
| 3. Intelligent tester operation (1) Select IMMOBILISER (2) Select ID UTILITY (3) Select IMMOB CODE REG
| Within 120 sec. | OFF |
| 4. Remove the master key. | Within 20 sec. of the instruction on the tester | ON |
| 5. Insert the key to be registered in the ignition key cylinder. | Within 10 sec. | |
6. After 60 sec. the key is registered.
| - | Blinking |
| 7. Next | OFF | |
| 8. End | ||
| 4. ERASURE OF KEY CODE |
Erase key codes by using the intelligent tester.
| Procedure | Time (Operation Completion Time) | Security Indicator Condition |
| 1. Start | - | Indicator blinks until the first key is inserted. |
| 2. Insert the already registered master-key in the ignition key cylinder and turn the ignition switch on. | ||
| 3. Intelligent tester operation (1) Select IMMOBILISER (2) Select ID UTILITY (3) Select IMMOB CODE ERA
| Within 120 sec. | OFF |
| 4. Remove the master key. | Within 10 sec. of the instruction on the tester | ON for 1 sec. then OFF |
| 5. Next | - | Blinking |
| 6. End | ||
| 5. ECU COMMUNICATION ID REGISTRATION |
ECU communication ID registration (Procedure "C"):
Register the ECU COMMUNICATION ID, after the transponder key ECU and/or the ECM is replaced turn the ignition switch to the ON position.
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position and leave it as is for 30 minutes.
Check that the engine starts.