Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E120046E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E120030E04
  1. Disconnect the radio receiver connector R1 or R2.

  1. Measure the resistance according to the value in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    GND - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the values in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    +B - GND (*1)
    Always
    10 to 14 V
    B - GND (*2)
    Always
    10 to 14 V
    ACC - GND
    Ignition SW ACC
    10 to 14 V

    *1: 6 Speaker
    *2: 10 Speaker



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE