Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit


DESCRIPTION

This circuit provides power to operate the theft warning ECU.

WIRING DIAGRAM


B139461E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room J/B.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE)


    B063408E01
  1. Remove the T5 ECU assembly with the connector still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Symbol (Tester Connection)
    Specified Condition
    +B1 (T5-2) - Body ground
    10 to 14 V



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
NG


3.CHECK HARNESS AND CONNECTOR (GROUND)


    B063408E01
  1. Disconnect the T5 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    E (T5-29) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY