Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Ignition Switch Circuit


DESCRIPTION

When the ignition switch is turned to the ON position, battery positive voltage is applied to terminal IG of the ECU. When battery positive voltage is applied to terminal IG of the ECU while the theft deterrent system is operating, the warning stops.

WIRING DIAGRAM


B139460E01


INSPECTION PROCEDURE

1.INSPECT FUSES (ECU-IG)
  1. Remove the ECU-IG fuse from the instrument panel J/B.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSES
OK


2.INSPECT IGNITION SWITCH ASSEMBLY
  1. Disconnect the I18 switch connector.



    B110511E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    2 - 4
    ON
    Below 1 Ω



NG
REPLACE IGNITION SWITCH ASSEMBLY
OK


3.CHECK HARNESS OR CONNECTOR (POWER SOURCE)


    B063408E01
  1. Disconnect the T5 ECU connector.

  1. Turn the ignition switch ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Symbol (Tester Connection)
    Specified Condition
    IG (T5-10) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY