Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The engine hood courtesy switch is built in the engine hood lock assembly. The switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM


B134206E01


INSPECTION PROCEDURE

1.INSPECT ENGINE HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)


    B064979E01
  1. Remove the courtesy switch from hood lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Pushed:
    OFF (Lock)
    10 kΩ or higher
    1 - 4
    Not pushed:
    ON (Unlock)
    Below 1 Ω



NG
REPLACE ENGINE HOOD LOCK ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - ENGINE HOOD COURTESY SWITCH)


    B064977E01
  1. Disconnect the T5 ECU connector and E3 courtesy switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    DSWH (T5-34) - (E3-1)
    Below 1 Ω
    DSWH (T5-34) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)


    B110538E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E3-4 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY