Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Horn Circuit


DESCRIPTION

During the alarm sounding state, the relay in the ECU turns on and off in a cycle of approximately 0.2 seconds, causing the security horn to sound.

WIRING DIAGRAM


B110509E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY)


    B063408E01
  1. Disconnect the T5 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Symbol (Tester Connection)
    Specified Condition
    +B2 (T5-3) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT SECURITY HORN ASSEMBLY


    B070004
  1. Disconnect the T1 security horn connector.

  1. Check the operation of the security horn.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Horn body
    Security horn sounds



NG
REPLACE SECURITY HORN ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - SECURITY HORN ASSEMBLY)


    B112146E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    SH- (T5-1) - (T1-1)
    Below 1 Ω
    SH- (T5-1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY