QUARTER WINDOW GLASS > INSTALLATION |
| 1. INSTALL STOPPER CUSHION |
Clean the installation area.
Install 4 new spacers onto the glass.
| 2. INSTALL QUARTER WINDOW ASSEMBLY LH |
![]() |
Clean and shape the contact surface of the vehicle body.
Using a knife, cut away any rough adhesive on the contact surface of the vehicle body to ensure the appropriate surface shape.
Clean the contact surface of the vehicle body with a piece of shop rag saturated with cleaner.
![]() |
Using a brush, coat the exposed part of the vehicle body on the vehicle side with Primer M.
![]() |
Using brush or sponge, coat the edge of the glass and the contact surface with Primer G.
| A | 20.0 mm (0.787 in.) |
| B | 26.0 mm (1.024 in.) |
| C | 5.0 mm (0.197 in.) |
![]() |
Apply adhesive (Adhesive: Part No. 08850-00801 or equivalent).
Cut off the tip of the cartridge nozzle, as shown in the illustration.
| Temperature | Usage Timeframe |
| 35°C (95°F) | 15 minutes |
| 20°C (68°F) | 1 hour 40 minutes |
| 5°C (41°F) | 8 hours |
Load the sealer gun with the cartridge.
Coat the glass with adhesive, as shown in the illustration.
| Area | Measurement |
| A | 12.0 mm (0.472 in.) |
| B | 8.0 mm (0.315 in.) |
| C | 13.0 mm (0.512 in.) |
| D | 13.0 mm (0.512 in.) |
| E | 8.0 mm (0.315 in.) |
Install the quarter window to the vehicle body.
Hold the quarter window in place securely with protective tape or equivalent until the adhesive hardens.
Lightly press the front surface for close contact.
![]() ![]() |
Using a scraper, remove any excess or protruding adhesive.
| Temperature | Minimum time prior to driving vehicle |
| 35°C (95°F) | 1 hour 30 minutes |
| 20°C (68°F) | 5 hours |
| 5°C (41°F) | 24 hours |
| 3. CHECK FOR LEAKS AND REPAIR |
Conduct a leak test after the adhesive has completely hardened.
Seal any leaks with auto glass sealer.
| 4. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER LH |
| 5. INSTALL REAR NO.2 SEAT BELT ASSEMBLY OUTER LH (w/ Rear No. 2 Seat) |