Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE


    C125286
  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission wire connector.



2. CONNECT TRANSMISSION WIRE


    C125285E01
  1. Connect the 7 connectors to the solenoid valves.

  1. Install the clamp with the 2 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf } for bolt A
    11 N*m{ 110 kgf*cm , 8 ft.*lbf } for bolt B

    HINT:
    Each bolt length is indicated below.

    Standard bolt length:
    36 mm (1.42 in.) for bolt A
    12 mm (0.47 in.) for bolt B

  1. Connect the ATF temperature sensor.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    D028692E01
  1. Install a new O-ring and the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

HINT:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.



    C125287
  1. Install the oil pan with the 20 bolts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }



5. ADD AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)



6. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)