Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


    D028696E01
  1. Insert the pin of the lever into the hole of the manual valve.

  1. Install 3 new drum seal gaskets onto the transmission case.



    D028694E02
  1. Install the 19 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.

    Standard bolt length:
    36 mm (1.42 in.) for bolt A
    25 mm (0.98 in.) for bolt B



2. CONNECT TRANSMISSION WIRE


    D012704E03
  1. Connect the 7 connectors to the solenoid valves.

  1. Install the clamp with the 2 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf } for bolt A
    11 N*m{ 112 kgf*cm , 8 ft.*lbf } for bolt B

    HINT:
    Each bolt length is indicated below.

    Standard bolt length:
    12 mm (0.47 in.) for bolt A
    36 mm (1.42 in.) for bolt B

  1. Connect the ATF temperature sensor.
    Sensor wire harness: 
    Wire harness
    Color
    for liner control
    Orange
    for oil temp. warning light
    Blue



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    D028692E01
  1. Install a new O-ring and the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

HINT:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.



    C123815
  1. Install the new gasket and the oil pan with the 20 bolts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }



5. ADD AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)



6. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)