VALVE BODY ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Insert the pin of the lever into the hole of the manual valve.
Install 3 new drum seal gaskets onto the transmission case.
![]() |
Install the 19 bolts.
| 2. CONNECT TRANSMISSION WIRE |
![]() |
Connect the 7 connectors to the solenoid valves.
Install the clamp with the 2 bolts.
Connect the ATF temperature sensor.
| Wire harness | Color |
| for liner control | Orange |
| for oil temp. warning light | Blue |
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Install a new O-ring and the oil strainer with the 4 bolts.
| 4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
![]() |
Install the new gasket and the oil pan with the 20 bolts.
| 5. ADD AUTOMATIC TRANSMISSION FLUID |
| 6. INSPECT AUTOMATIC TRANSMISSION FLUID |