Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. REMOVE TRANSMISSION OIL FILTER TUBE SUB-ASSEMBLY


3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

NOTICE:
Some fluid will remain in the oil pan.



    C123815
  1. Remove the 20 bolts and oil pan.



    AT00103E01
  1. Examine the particles in the oil pan.

    1. Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bushing wear



4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    D028692E01
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid may leak out of the oil strainer.



5. DISCONNECT TRANSMISSION WIRE


    D028693E01
  1. Remove the 2 bolts and clamp.

  1. Disconnect the ATF temperature sensor.

  1. Disconnect the 7 connectors from the solenoid valves.



6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    D028694E01
  1. Remove the 19 bolts and valve body.

  1. Remove the 3 drum seal gaskets.