Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    D027961E01
  1. Using SST and a hammer, install a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the oil seal lip with MP grease.



2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D027959E01
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D027958E01
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.



5. INSTALL FRONT OIL PUMP BODY O-RING


    D027963E01
  1. Install a new O-ring to the oil pump body.



6. INSTALL STATOR SHAFT ASSEMBLY


    D027953E01
  1. Install the stator shaft with each bolt hole.

  1. Install the 14 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



7. INSTALL CLUTCH DRUM OIL SEAL RING


    D027952E03
  1. Coat the 3 oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with the overlap distance 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



8. INSPECT OIL PUMP DRIVE GEAR ROTATION


    D027962E01
  1. Make sure the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.



9. INSTALL FRONT OIL PUMP BODY O-RING


    D027950E01
  1. Install a new O-ring to the oil pump assembly.