REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU |
| TELEVISION CAMERA ASSEMBLY |
Disconnect the T11 camera connector.

Measure the voltage and resistance of each terminal of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified value |
| CGND (T11-2) - Body ground | W - Body ground | Ground | Always | Below 1 Ω |
| CB+ (T11-1) - CGND (T11-2) | R - W | Power source | Ignition switch ON, shift lever R position | Approx. 6 V |
Reconnect the T11 camera connector.
Measure the voltage and frequency of each terminal of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified value |
| CV+ (T11-4) - CV- (T11-3) | B - Shielded | Display signal | Ignition switch ON, shift lever R position | See waveform 1 |
![]() |
Reference:
Oscilloscope waveform
Waveform 1
| Item | Content |
| Measure terminal | CV+ - CV- |
| Measure set | 0.2 V/DIV., 0.2 μS/DIV. |
| Condition | Ignition switch: ON, Shift lever: R position |
| RADIO AND NAVIGATION ASSEMBLY (Click here) |