AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.INSPECT STEREO COMPONENT AMPLIFIER |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MUTE - Body ground | Turn ignition switch to ACC, Audio system is playing → Changing | Above 3.5 V → Below 1 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the radio receiver connector R1 and stereo component amplifier connector S22.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MUTE - MUTE | Always | Below 1 Ω |
| MUTE - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE WOOFER BOX SPEAKER ASSEMBLY (BUILT-IN STEREO COMPONENT AMPLIFIER) |
Replace the stereo component amplifier and check if the audio system operates normally.
|
| ||||
| NG | ||
| ||