Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSPECTION



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


    B062851E01
  1. Disconnect the mirror connector.

  1. Apply battery voltage and check operation of the mirror face, as shown in the table and illustration.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (MV)
    Battery negative (-) → Terminal 1 (M+)
    Turns upward (A)
    Battery positive (+) → Terminal 1 (M+)
    Battery negative (-) → Terminal 3 (MV)
    Turns downward (B)
    Battery positive (+) → Terminal 1 (M+)
    Battery negative (-) → Terminal 2 (MH)
    Turns right (C)
    Battery positive (+) → Terminal 2 (MH)
    Battery negative (-) → Terminal 1 (M+)
    Turns left (D)

    If the result is not as specified, replace the mirror assembly.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


    B062850E01
  1. Inspect outer mirror motor operation.

  1. Apply battery voltage and check operation of the mirror face, as shown in the table and illustration.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (MV)
    Battery negative (-) → Terminal 1 (M+)
    Turns upward (A)
    Battery positive (+) → Terminal 1 (M+)
    Battery negative (-) → Terminal 3 (MV)
    Turns downward (B)
    Battery positive (+) → Terminal 1 (M+)
    Battery negative (-) → Terminal 2 (MH)
    Turns right (C)
    Battery positive (+) → Terminal 2 (MH)
    Battery negative (-) → Terminal 1 (M+)
    Turns left (D)

    If the result is not as specified, replace the mirror assembly.