Home › ENGINE ยท 1GR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A075657E01
  1. Install the vacuum hose.

  1. Apply a light coat of spindle oil or gasoline to a new O-ring and install it onto the fuel pressure regulator.

  1. Install the fuel pressure regulator with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



2. CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY


3. INSTALL AIR CLEANER ASSEMBLY


    A075596E01
  1. Install the air cleaner with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Tighten the 2 hose clamps.



    A075595E01
  1. Install the 2 wire harness clamps.

  1. Connect the mass air flow meter connector.

  1. Connect the vacuum hose.



    A075594E01
  1. Connect the ventilation hose No. 2.



4. CONNECT NO. 2 VENTILATION HOSE


    A075594
  1. Connect the No. 2 ventilation hose.



5. INSTALL V-BANK COVER


    A075593E01
  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



7. CHECK FOR FUEL LEAKAGE