Home › DRIVE LINE ยท DIFFERENTIAL › REAR DIFFERENTIAL CARRIER OIL SEAL

REAR DIFFERENTIAL CARRIER OIL SEAL > REMOVAL

for Preparation Click here



1. DRAIN DIFFERENTIAL OIL


    D025304E03
  1. Stop the vehicle on a level place.

  1. Remove the differential filler plug and gasket.

  1. Check that the oil level is within 5mm (0 to 0.20 in.) of the bottom of the filler plug opening.

    NOTICE:
    1. Excessively large or small quantities of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

    HINT:
    If necessary, fill the rear differential carrier assembly with hypoid gear oil.

    Oil grade:
    Hypoid gear oil API GL-5
    Recommended viscosity:
    Above -18°C (0°F) SAE 90
    Below -18°C (0°F) SAE 80W or 80W-90

    Capacity:
    Front differential carrier assembly:
    1.35 to 1.45 litters
    (1.43 to 1.53 US qts, 1.19 to 1.27 lmp. qts)
    Rear differential carrier assembly
    3.00 to 3.10 litters
    (3.17 to 3.27 US qts, 2.64 to 2.72 lmp. qts)

  1. Check for oil leakage if the oil level is low.

  1. Install the differential filler plug and a new gasket.

    Torque:
    Front differential carrier assembly:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }
    Rear differential carrier assembly:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



2. REMOVE PROPELLER SHAFT ASSEMBLY


    C060588E02
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. 2WD Drive Type:
    Remove the 4 nuts and 4 washers.

  1. 4WD Drive Type:
    Remove the 4 nuts, 4 bolts and 4 washers.

  1. Suspend the propeller shaft assembly with wire or similar.



3. REMOVE REAR DRIVE PINION NUT


    C089309E02
  1. Using SST and a hammer, unstake the nut.

    SST
    09930-00010  



    C088916E01
  1. Using SST to hold the companion flange, remove the nut.

    SST
    09330-00021  



4. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY REAR


    F040720E02
  1. Using SST, remove the companion flange.

    SST
    09950-30012   (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03030)



5. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL


    F040717E02
  1. Using SST, remove the oil seal.

    SST
    09308-10010  



6. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER


7. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING


    W001770E03
  1. Using SST, remove the front bearing.

    SST
    09556-22010  

  1. Using SST, remove the front bearing outer race.

    SST
    09308-00010  

  1. Using a screwdriver, bend the oil storage ring and remove it.



8. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER