Home › DRIVE LINE ยท VF4BM TRANSFER › TRANSFER OIL

TRANSFER OIL > ADJUSTMENT

for Preparation Click here



1. INSPECT TRANSFER OIL


C083746E02
  1. Remove the filler plug and gasket.

  1. Check that the oil level is within 5 mm (0.20 in.) of the bottom of the filler plug hole.

    NOTICE:
    1. When replacing the oil, recheck the oil level after driving.
    2. Excessively large or small quantities of oil may cause troubles.

  1. When the oil level is too low, check for oil leakage.

  1. Tighten the filler plug with a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. ADJUST TRANSFER OIL
  1. Remove the filler plug and gasket then supply oil.

    NOTICE:
    1. When supplying oil, pour slowly.
    2. Pour the oil in several stages allowing several minutes between each step.

    HINT:
    The oil level should be within 5 mm (0.20 in.) of the bottom of the oil filler plug hole.

  1. After leaving it alone for 5 minutes, check the oil level again.

  1. Tighten the filler plug with a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }