Home › DRIVE LINE ยท DRIVE SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. DRAIN DIFFERENTIAL OIL


    D025304E03
  1. Stop the vehicle on a level place.

  1. Remove the differential filler plug and gasket.

  1. Check that the oil level is within 5mm (0 to 0.20 in.) of the bottom of the filler plug opening.

    NOTICE:
    1. Excessively large or small quantities of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

    HINT:
    If necessary, fill the rear differential carrier assembly with hypoid gear oil.

    Oil grade:
    Hypoid gear oil API GL-5
    Recommended viscosity:
    Above -18°C (0°F) SAE 90
    Below -18°C (0°F) SAE 80W or 80W-90

    Capacity:
    Front differential carrier assembly:
    1.35 to 1.45 litters
    (1.43 to 1.53 US qts, 1.19 to 1.27 lmp. qts)
    Rear differential carrier assembly
    3.00 to 3.10 litters
    (3.17 to 3.27 US qts, 2.64 to 2.72 lmp. qts)

  1. Check for oil leakage if the oil level is low.

  1. Install the differential filler plug and a new gasket.

    Torque:
    Front differential carrier assembly:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }
    Rear differential carrier assembly:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



3. REMOVE FRONT AXLE HUB LH NUT


    F042732
  1. Remove the cotter pin and a adjusting cap.

  1. Remove the front axle hub LH nut.



4. SEPARATE FRONT SPEED SENSOR


F042730
  1. Using a hexagon wrench, separate the front speed sensor.

  1. Disengage the 2 clamps.

  1. Remove the bolt and separate the speed sensor wire harness from the steering knuckle.



5. SEPARATE TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    F042735
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



6. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM SUB-ASSEMBLY


F042737
  1. Remove the 2 bolts and separate the No. 1 front suspension lower arm sub-assembly from the steering knuckle.



7. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


F042739E01
  1. Using SST, remove the front drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Be careful not to damage the oil seal.



8. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
Remove the RH side by the same procedure with LH side.

SST
09520-01010  
09520-24010   (09520-32040)