Home › DRIVE LINE ยท DRIVE SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP


F043637
  1. Using a screwdriver, disclamp the inboard joint boot clamp.

  1. Using the same manner to the inboard joint small boot clamp.



2. SEPARATE INBOARD JOINT BOOT


3. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY


FA01615E03
  1. Place matchmarks on the tripod, inboard and outboard joint shafts.

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.



    G022501
  1. Using a snap ring expander, remove the snap ring.



    N000194E02
  1. Place matchmarks on the outboard joint shaft and tripod.

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, remove the tripod from the drive shaft.

    NOTICE:
    Do not tap the roller.



4. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP


    C063445
  1. Using a screwdriver, disclamp the inboard joint boot clamps.

    HINT:
    If the outboard joint boot clamps that have been replaced are installed to the drive shaft, use a side cutter to remove them.

  1. Using the same manner to the outboard joint small boot clamp.



5. REMOVE OUTBOARD JOINT BOOT


6. REMOVE FRONT DRIVE INNER SHAFT OUTER SHAFT SNAP RING


C057543
  1. Using a screwdriver, remove the snap ring.



7. REMOVE FRONT DRIVE SHAFT DUST COVER


F040647E01
  1. Using SST and a press, remove the dust cover.

    SST
    09950-00020  



8. REMOVE STEERING KNUCKLE LH OIL SEAL


C034791
  1. Using a screwdriver and a hammer, remove the oil seal.