Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 2WD)

FRONT AXLE HUB (for 2WD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT SPEED SENSOR


    F042730
  1. Using a hexagon wrench, separate the front speed sensor.

  1. Disconnect the 2 clamps.

  1. Remove the bolt and separate the speed sensor wire harness from the steering knuckle.



3. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY


    F042731
  1. Remove the bolt and separate the brake tube bracket from the steering knuckle.

  1. Using SST, disconnect the brake tube from the front disc brake caliper assembly.

    SST
    09023-00101  



    F043121
  1. Remove the 2 bolts and front disc brake caliper assembly.



4. REMOVE FRONT DISC


5. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    C099158
  1. Remove the nut and separate the stabilizer link assembly from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



6. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.



    F042735E02
  1. Using SST, separate the tie rod end sub-assembly from the steering knuckle.

    SST
    09628-62011  



7. SEPARATE NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER


    F042737
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the front axle.



8. SEPARATE FRONT SUSPENSION UPPER ARM ASSEMBLY


    F042736E01
  1. Remove the clip and nut.

  1. Using SST, separate the steering knuckle from the front suspension upper arm assembly.

    SST
    09628-62011  



9. REMOVE FRONT AXLE HUB SUB-ASSEMBLY
  1. 4WD Drive Type:
    Using a plastic hammer, separate the front axle hub from the front drive shaft.

  1. Remove the front axle hub sub-assembly.