FRONT AXLE HUB (for 4WD) > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. SEPARATE FRONT SPEED SENSOR |
![]() |
Using a hexagon wrench, separate the speed sensor front.
Disengage the 2 clamps.
Remove the bolt and separate the speed sensor wire harness from the steering knuckle.
| 3. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the bolt and separate the brake tube bracket from the steering knuckle.
Using SST, disconnect the brake tube from the disc brake cylinder.
![]() |
Remove the 2 bolts and front disc brake caliper assembly.
| 4. REMOVE FRONT DISC |
| 5. REMOVE FRONT AXLE HUB GREASE CAP |
![]() |
Using a screwdriver and a hammer, remove the front axle hub grease cap.
| 6. REMOVE FRONT AXLE HUB NUT |
![]() |
Remove the cotter pin and a lock cap.
Remove the front axle hub nut.
| 7. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the stabilizer link assembly from the steering knuckle.
| 8. SEPARATE TIE ROD END SUB-ASSEMBLY |
![]() |
Remove the cotter pin and nut.
Using SST, separate the tie rod end sub-assembly from the steering knuckle.
| 9. REMOVE NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER |
![]() |
Remove the 2 bolts and separate the No.1 front suspension arm sub-assembly lower from the front steering knuckle.
| 10. SEPARATE FRONT SUSPENSION UPPER ARM ASSEMBLY |
![]() |
Remove the cotter pin and nut.
Using SST, separate the steering knuckle from the front suspension upper arm assembly LH.
| 11. REMOVE FRONT AXLE HUB ASSEMBLY |
for 4WD:
Using a plastic hammer, separate the front axle hub from the front drive shaft.
Remove the front axle hub assembly.