Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR SPEED SENSOR


    F043111
  1. Disconnect the speed sensor connector.



    F043113
  1. Remove the nut and speed sensor rear from the axle hub.

    NOTICE:
    1. Do not stick and foreign matter on the sensor tip.
    2. Do not let the foreign matter into the sensor installation hole.



3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    F043124
  1. Remove the 2 cylinder slide pins from disc brake cylinder assembly rear.

  1. Remove the disc brake cylinder assembly rear from rear disc brake cylinder mounting.



4. REMOVE REAR DISC


5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING


    D028127
  1. Using a needle-nose pliers, remove the 2 return tension springs.



6. REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING
  1. Slide out the front shoe and remove the compression spring.



7. REMOVE PARKING BRAKE SHOE STRUT


8. REMOVE PARKING BRAKE SHOE
  1. Release the cup claw and remove the front and rear parking brake shoe.

  1. Disconnect the parking brake cable from the shoe lever.

  1. Remove the tension spring and shoe adjuster screw set from the front rear shoe.

  1. Remove the 2 shoe hold-down springs, 4 cups and 2 pins.

  1. Using a screwdriver, remove the C-washer.

  1. Remove the shim and shoe lever from the parking brake shoe.



9. REMOVE REAR AXLE SHAFT WITH BACKING PLATE


    F042741
  1. Remove the 4 nuts and rear axle shaft with backing plate.

  1. Remove the O-ring.



10. REMOVE REAR AXLE SHAFT OIL SEAL


    F042742E01
  1. Using SST, remove the rear axle shaft oil seal.

    SST
    09308-00010  



11. REMOVE REAR AXLE SHAFT SNAP RING


    F042773
  1. Using a snap ring expander, remove the snap ring.



12. REMOVE REAR AXLE SHAFT


    F042774E01
  1. Using SST and press, remove the rear axle shaft.

    SST
    09521-25011  
    09521-25023