Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR AXLE BEARING RETAINER INNER
  1. Remove the rear axle bearing retainer inner from the rear axle bearing assembly.



2. REMOVE REAR AXLE SHAFT WASHER
  1. Remove the rear axle shaft washer from the rear axle bearing assembly.



3. REMOVE PARKING BRAKE PLATE TO REAR AXLE HOUSING BOLT


    F042776
  1. Attach the 4 nuts to the parking brake plate to rear axle housing bolts.

  1. Using a hammer, remove the 4 parking brake plate to rear axle housing bolts and rear axle bearing assembly.

    NOTICE:
    Do not reuse the nuts previously removed from the vehicle.



4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


5. REMOVE REAR AXLE HUB BOLT


    F042775E01
  1. Using SST, remove the 6 hub bolts.

    SST
    09650-17011  



6. REMOVE BRAKE DRUM OIL DEFLECTOR


7. REMOVE BRAKE DRUM OIL DEFLECTOR GASKET


8. REMOVE REAR AXLE BEARING OIL SEAL


    F042797
  1. Grind the rear axle bearing inner race surface using a grinder, then chisel them out with a chisel.

  1. Remove the rear axle shaft oil seal from the rear axle shaft.



9. INSPECT REAR AXLE SHAFT


R012254
  1. Using a dial indicator, measure the runout of the shaft and flange.

    Maximum runout:
    Shaft runout: 1.5 mm (0.0591 in.)
    Flange runout: 0.05 mm (0.0020 in.)

    If the rear axle shaft or flange is damaged or worn, or the runout is greater than the maximum, replace the rear axle shaft.