Home › BRAKE › BRAKE › HYDRAULIC BRAKE BOOSTER

HYDRAULIC BRAKE BOOSTER > REMOVAL

for Preparation Click here


NOTICE:
  1. When installing, coat the parts indicated by arrows with lithium soap base glycol grease (Click here).
  2. As high pressure is applied to the brake actuator tube No. 1, never deform it.
  3. Until the work is over, do not turn the ignition switch to the ON position.
  4. Before starting the work, make sure that the ignition switch is off and depress the brake pedal more than 20 times.

HINT:
When pressure in the power supply system is released, reaction force becomes light and stroke becomes longer.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes into contact with a painted surface.



3. REMOVE FRONT DOOR SCUFF PLATE LH


4. REMOVE FRONT FLOOR FOOTREST


5. REMOVE COWL SIDE TRIM BOARD LH


6. REMOVE INSTRUMENT PANEL FINISH PLATE


    B062737
  1. Remove the instrument panel finish plate.



7. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER


    B062738E01
  1. Remove the 2 bolts <B>.

  1. Disconnect the hood lock control cable assembly and fuel lid lock control cable sub-assembly.

  1. Disengage the 4 clips.

  1. Disconnect the connectors and remove the lower instrument panel finish panel sub-assembly.



8. REMOVE STEERING COLUMN HOLE COVER
  1. Remove the 4 clips and steering column hole cover.



9. REMOVE PUSH ROD PIN


    F051429E01
  1. Remove the clip and push rod pin from the clevis.



10. REMOVE HYDRAULIC BRAKE BOOSTER ASSEMBLY


    F051438E02
  1. Disconnect the 3 connectors from the hydraulic brake booster assembly.



    F051200E01
  1. Use tags or make a memo to identify the place to reconnect.



    F051171E01
  1. Using SST, disconnect the 4 brake lines from the hydraulic brake booster assembly.

    SST
    09023-00101  



    F051420
  1. Remove the 4 nuts and pull out the hydraulic brake booster assembly.



11. REMOVE BRAKE BOOSTER GASKET
  1. Remove the brake booster gasket from the brake master cylinder.