ENGINE OIL COOLER > REMOVAL |
| 1. DRAIN ENGINE COOLANT |
![]() |
Remove the service hole cover from the engine under cover.
Install a vinyl hose onto the drain on the radiator side.
Fix the vinyl hose with tape.
![]() |
Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.
Remove the radiator cap.
Drain the coolant from the reservoir tank.
Tighten the 3 drain plugs.
Remove the vinyl hose from the radiator.
| 2. REMOVE OIL FILTER SUB-ASSEMBLY |
![]() |
Remove the drain pipe cap.
While removing the oil filter with SST, catch the oil from the oil filter with a container.
Install the drain pipe cap.
![]() |
Clean the oil catch plate.
Remove the drain pipe cap.
Connect a drain hose to the oil filter bracket.
Feed the drain hose down through the engine under cover, and put the drain oil container beneath the drain hose to catch the oil from the oil filter.
![]() |
Using SST, remove the oil filter.
Remove the drain hose and install the drain pipe cap.
Clean the oil catch plate.
| 3. REMOVE V-BANK COVER |
![]() |
Remove the 2 nuts, then remove the V-bank cover.
| 4. REMOVE OIL COOLER ASSEMBLY |
Disconnect the 2 oil cooler hoses from the oil cooler.
![]() |
Remove the union bolt, plate washer and oil cooler.
Remove the O-ring from the oil cooler.