Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › FUEL PUMP RELAY

FUEL PUMP RELAY > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP RELAY ASSEMBLY


    A094494E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Resistance:
      Tester Connection
      Specified Condition
      3 - 4
      Below 1 Ω
      3 - 5
      10 kΩ or higher
      3 - 4
      10 kΩ or higher
      (Apply battery voltage to terminals 1 and 2)
      3 - 5
      Below 1 Ω
      (Apply battery voltage to terminals 1 and 2)

      If the result is not as specified, replace the fuel pump relay.