2UZ-FE FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > REMOVAL |
| 1. REMOVE FRONT WHEELS |
| 2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY |
Remove the 6 bolts and engine under cover assembly.
| 3. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts and No. 1 engine under cover sub-assembly.
| 4. DRAIN DIFFERENTIAL OIL |
![]() |
Stop the vehicle on a level place.
Remove the differential filler plug and gasket.
Check that the oil level is within 5mm (0 to 0.20 in.) of the bottom of the filler plug opening.
Check for oil leakage if the oil level is low.
Install the differential filler plug and a new gasket.
| 5. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
![]() |
Place matchmarks on the propeller shaft flange and differential.
Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft assembly.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts, 4 washers and front propeller shaft assembly.
| 6. REMOVE FRONT AXLE HUB LH NUT |
![]() |
Remove the cotter pin and a lock cap.
Remove the front axle hub nut.
| 7. REMOVE FRONT AXLE HUB RH NUT |
| 8. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Remove the 2 nuts and the front stabilizer link assembly LH.
| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH |
| 10. SEPARATE FRONT SPEED SENSOR LH |
![]() |
Disconnect the speed sensor connector.
![]() |
Using a hexagon wrench (5 mm), remove the bolt and front speed sensor from the steering knuckle.
| 11. SEPARATE FRONT SPEED SENSOR RH |
| 12. SEPARATE TIE ROD SUB-ASSEMBLY LH |
![]() |
Remove the cotter pin and nut.
Using SST, separate the tie rod end from the steering knuckle arm.
| 13. SEPARATE TIE ROD SUB-ASSEMBLY RH |
| 14. REMOVE NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER LH |
![]() |
Remove the 2 bolts, and separate the front lower ball joint attachment LH from the front axle.
![]() |
Place matchmarks on the camber adjust cam No. 2 and toe adjust cam sub-assembly.
Remove the nut, camber adjust cam No. 2, camber adjust cam assembly, bolt, toe adjust cam sub-assembly, toe adjust plate No. 2 and front suspension arm sub-assembly lower No. 1 LH.
![]() |
Remove the cotter pin and the nut.
Using SST, remove the front lower ball joint attachment LH.
| 15. REMOVE NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER RH |
| 16. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the front drive shaft.
| 17. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
| 18. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY |
![]() |
Remove the bolt and separate the front differential breather tube bracket.
Support the front differential with a jack.
Remove the front differential mount nut No. 1.
Remove the 2 front mounting bolts and 2 nuts.
Lower the jack and remove the front differential assembly.
Remove the 2 bolts and No. 3 front differential support.
Remove the 5 bolts and 2 front differential supports.