ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE COOLANT |
| 2. INSPECT ENGINE OIL |
| 3. INSPECT BATTERY |
| 4. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 5. INSPECT DRIVE BELT |
| 6. INSPECT IGNITION TIMING |
Warm up the engine.
![]() |
When using the intelligent tester.
Connect the intelligent tester to the DLC3.
Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / DATA LIST / IGN ADVANCE.
Inspect the ignition timing during idling.
Check that the ignition timing advances immediately when the engine speed is increased.
![]() |
When not using intelligent tester.
Using SST, connect the terminals 13 (TC) and 4 (CG) of the DLC3.
Remove the air cleaner cap sub-assembly.
![]() |
Pull out the wire harness as shown in the illustration.
Connect the tester probe of a timing light to the wire of the ignition coil connector for No. 1 cylinder.
![]() |
Inspect the ignition timing during idling.
Remove the SST from the DLC3.
Inspect the ignition timing during idling.
Disconnect the timing light from the engine.
Install the air cleaner cap sub-assembly.
| 7. INSPECT ENGINE IDLING SPEED |
Warm up the engine.
![]() |
When using the intelligent tester:
Connect the intelligent tester to the DLC3.
Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / DATA LIST / ENGINE SPD.
Inspect the engine idling speed.
![]() |
When not using the intelligent tester:
Using SST, connect the terminal 8 (TAC) of the DLC3.
Race the engine speed at 2,500 rpm for approximately 90 seconds.
Inspect the engine idling speed.
| 8. INSPECT COMPRESSION |
Warm up and stop the engine.
Remove the V-bank cover.
Remove the air cleaner assembly.
Remove the intake air surge tank .
Remove the 6 ignition coils.
Remove the 6 spark plugs.
Disconnect the 6 injector connectors.
![]() |
Inspect the cylinder compression pressure.
Insert a compression gage into the spark plug hole (Procedure "A").
Fully open the throttle (Procedure "B").
While cranking the engine, measure the compression pressure (Procedure "C").
Repeat procedures "A" through "C" for each cylinder.
If the cylinder compression is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat procedures "A" through "C" for cylinders with low compression.
Connect the 6 injector connectors.
Install the 6 spark plugs.
Install the 6 ignition coils.
Install the intake air surge tank .
Install the air cleaner assembly.
Install the V-bank cover.
| 9. INSPECT CO/HC |
Start the engine.
Run the engine at 2,500 rpm for approximately 180 seconds.
![]() |
Insert the CO/HC meter testing probe at least 40 cm (1.3 ft) into the tailpipe during idling.
Immediately check the CO/HC concentration during idling and/or at 2,500 rpm.
If the CO/HC concentration does not comply with regulations, troubleshoot in the order given below.
Check the A/F sensor and heated oxygen sensor operation.
See the table below for possible causes, then inspect and correct the applicable causes if necessary.
| CO | HC | Symptom | Causes |
| Normal | High | Rough idling |
|
| Low | High | Rough idling (Fluctuating HC reading) |
|
| High | High | Rough idling (Black smoke from exhaust) |
|