Home › ENGINE ยท 1GR-FE › LUBRICATION › OIL FILTER

OIL FILTER > INSTALLATION

for Preparation Click here



1. INSTALL OIL FILTER SUB-ASSEMBLY


    A076324E01
  1. Clean the oil filter contact surface on the oil filter bracket.

  1. Lubricate the rubber gasket of a new oil filter with clean engine oil.

  1. Tighten the oil filter by hand until the rubber gasket comes into contact with the seat of the filter bracket.



    A076325E03
  1. Using SST, tighten it an additional 3/4 turn to set the filter.

    SST
    09228-07501  

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



2. ADD ENGINE OIL
  1. Fill with fresh engine oil.

    Capacity:
    Drain and refill with oil filter change
    5.2 liters (5.5 US qts, 4.6 lmp. qts)
    Drain and refill without oil filter change
    4.9 liters (5.2 US qts, 4.3 lmp. qts)
    Dry fill
    6.0 liters (6.3 US qts, 5.3lmp. qts)

  1. Reinstall the oil filler cap.



3. INSPECT ENGINE OIL LEAKS


4. INSPECT ENGINE OIL LEVEL