Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the navigation system will not function normally as the communication is discontinued.

INSPECTION PROCEDURE

1.INSPECT RADIO AND NAVIGATION ASSEMBLY
E120086E02
  1. Disconnect the radio and navigation assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ATX+ (R12-5) -
    ATX- (R12-15)
    Always
    60 to 80 Ω
    TXM+ (R11-9) -
    TXM- (R11-10)
    Always
    60 to 80 Ω



NG
REPLACE RADIO AND NAVIGATION ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR

HINT:
For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.



    1. Check for an open or short in all AVC-LAN circuits.


      E120087E02

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE