Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
While the intelligent tester is connected to the DLC3 with the ignition switch is turned to the ON position, the ABS, TRAC and VSC data list can be displayed. Follow the prompts on the tester screen to access the "DATA LIST".


Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
HB MOT RELAY
HB motor relay / ON or OFF
ON : During pump motor operation
OFF : No pump motor operation
-
SOL RELAY
Solenoid relay / ON or OFF
ON : Solenoid relay ON
OFF : Solenoid relay OFF
-
IDLE SW
Main idle switch / ON or OFF
ON : Accelerator pedal released
OFF : Accelerator pedal depressed
-
STOP LIGHT SW
Stop light switch / ON or OFF
ON : Brake pedal depressed
OFF : Brake pedal released
-
PKB SW
Parking brake switch / ON or OFF
ON : Parking brake applied
OFF : Parking brake released
-
RESERVOIR SW
Brake fluid level warning switch / ON or OFF
ON : Switch ON
OFF : Switch OFF
-
AIR BLD SUPPORT
Air bleed availability / SUPPORT or NOT SUP
SUPPORT: Support ON
NOT SUP: Support OFF
-
ABS OPERT FR
ABS operation (FR) / BEFORE or OPERATE
BEFORE : No ABS operation (FR)
OPERATE : During ABS operation (FR)
-
ABS OPERT FL
ABS operation (FL) / BEFORE or OPERATE
BEFORE : No ABS operation (FL)
OPERATE : During ABS operation (FL)
-
ABS OPERT RR
ABS operation (RR) / BEFORE or OPERATE
BEFORE : No ABS operation (RR)
OPERATE : During ABS operation (RR)
-
ABS OPERT RL
ABS operation (RL) / BEFORE or OPERATE
BEFORE : No ABS operation (RL)
OPERATE : During ABS operation (RL)
-
WHEEL SPD FR
Wheel speed sensor (FR) reading / Min.: 0 mph (0 km/h), Max.: 202 mph (326 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
WHEEL SPD FL
Wheel speed sensor (FL) reading / Min.: 0 mph (0 km/h), Max.: 202 mph (326 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
WHEEL SPD RR
Wheel speed sensor (RR) reading / Min.: 0 mph (0 km/h), Max.: 202 mph (326 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
WHEEL SPD RL
Wheel speed sensor (RL) reading / Min.: 0 mph (0 km/h), Max.: 202 mph (326 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
DECELERAT SEN
Acceleration sensor 1 reading / Min.: -1.869 G, Max.: 1.869 G
Approximately 0 +- 0.13G while stationary
Reading changes when vehicle is bounced
DECELERAT SEN2
Acceleration sensor 2 reading / Min.: -1.869 G, Max.: 1.869 G
Approximately 0 +- 0.13G while stationary
Reading changes when vehicle is bounced
IG VOLTAGE
ECU IG power supply voltage / TOO LOW / NORMAL / TOO HIGH
TOO LOW: 9.5 V or less
NORMAL: 9.5 V or 14.0 V
TOO HIGH: 14.0 V or more
-
SFRR
ABS solenoid (SFRR) / ON or OFF
ON: Operates
-
SFRH
ABS solenoid (SFRH) / ON or OFF
ON: Operates
-
SFLR
ABS solenoid (SFLR) / ON or OFF
ON: Operates
-
SFLH
ABS solenoid (SFLH) / ON or OFF
ON: Operates
-
SRRR (SRR)
ABS solenoid (SRRR [SRR]) / ON or OFF
ON: Operates
-
SRRH (SRH)
ABS solenoid (SRRH [SRH]) / ON or OFF
ON: Operates
-
SRLR
ABS solenoid (SRLR) / ON or OFF
ON: Operates
-
SRLH
ABS solenoid (SRLH) / ON or OFF
ON: Operates
-
SRCF (SA1)
TRAC solenoid (SMCF) / ON or OFF
-
-
SRCR (SA2)
TRAC solenoid (SREA) / ON or OFF
-
-
SRMF (SMCF, SA3)
TRAC solenoid (SREC) / ON or OFF
-
-
SRMR (SMCR, STR)
TRAC solenoid (STR) / ON or OFF
-
-
ECU CODE #4
ECU CODE
1 or 0
0
ECU CODE #3
ECU CODE
1 or 0
0
ECU CODE #2
ECU CODE
1 or 0
0
ECU CODE #1
ECU CODE
1 or 0
0
ENGINE SPD
Engine Speed/ Min.: 0 rpm, Max.: 6000 rpm
Actual engine speed
-
VEHICLE SPD
Vehicle speed reading / Min.: 0 mph (0 km/h), Max.: 202 mph (326 km/h)
Actual engine speed
Speed indicated on speedometer
YAW RATE
Yaw rate sensor/ Min.: -128 deg/s, Max.: 127 deg/s
Min.: -128 deg/s
Max.: 127 deg/s
-
YAW ZERO VALUE
Memorized zero value/ Min.: -128 deg/s, Max.: 127 deg/s
Min.: -128 deg/s
Max.: 127 deg/s
-
STEERING ANG
Steering angle sensor/ Min.: -1152 deg/s, Max.: 1150.875 deg/s
Left turn: Increase
Right turn: Decrease
-
MAS CYL PRESS 1
Master cylinder pressure sensor 1 reading / Min.: 0V, Max.: 5V
When brake pedal is released : 0.3 to 0.9 V
When stop light is turned on: 0.3 to 0.9 V
Reading increases when brake pedal is depressed
ACC PRESS
Accumulator pressure sensor / Min.: 0V, Max.: 5V
3.58 to 5 V
If the value is constant regardless of pump operation, accumulator pressure sensor malfunction is suspected.
WHEEL DIR FR
Wheel direction (FR) / FORWARD or BACK
BACK: Back, FORWARD: Forward
-
WHEEL DIR FL
Wheel direction (FL) / FORWARD or BACK
BACK: Back, FORWARD: Forward
-
WHEEL DIR RR
Wheel direction (RR) / FORWARD or BACK
BACK: Back, FORWARD: Forward
-
WHEEL DIR RL
Wheel direction (RL) / FORWARD or BACK
BACK: Back, FORWARD: Forward
-
SPD SEN FR
Speed sensor open detection
(FR)/OPN DET or NORMAL
OPN DET: Momentary interruption
NORMAL: Normal
-
SPD SEN FL
Speed sensor open detection
(FL)/OPN DET or NORMAL
OPN DET: Momentary interruption
NORMAL: Normal
-
SPD SEN RR
Speed sensor open detection
(RR)/OPN DET or NORMAL
OPN DET: Momentary interruption
NORMAL: Normal
-
SPD SEN RL
Speed sensor open detection
(RL/OPN DET or NORMAL
OPN DET: Momentary interruption
NORMAL: Normal
-
ACCELERATOR %
The difference of a present accelerator / Min.: 0%, Max.: 128%
-
-
TORQUE
Real output torque /Min.: -1024 Nm, Max.: 1016 Nm
-
-
TEST MODE
Test mode operation / NORMAL or TEST
NORMAL: Normal mode
TEST: During test mode
-
MAS CYL PRESS 1
Master cylinder pressure sensor 1 reading / min.: 0V, max.: 5V
When brake pedal released: 0.3 to 0.9V
Reading increases when brake pedal depressed
#CODES
Number of DTC recorded / Min.: 0, Max.: 255
-
-

ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows the relay, actuator, etc. to operate without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one of the methods to shorten labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. According to the display on the tester, perform the "ACTIVE TEST".

    HINT:
    The ignition switch must be turned to the ON position to proceed to the ACTIVE TEST using the intelligent tester.


Item
Vehicle Condition / Test Details
Diagnostic Note
SFRR
Turns ABS solenoid (SFRR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SFRH
Turns ABS solenoid (SFRH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SFLR
Turns ABS solenoid (SFLR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SFLH
Turns ABS solenoid (SFLH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRRR
Turns ABS solenoid (SRRR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRRH
Turns ABS solenoid (SRRH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRLR
Turns ABS solenoid (SRLR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRLH
Turns ABS solenoid (SFLH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRCF (SA1)
Turns TRAC solenoid (SMCF) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRCR (SA2)
Turns TRAC solenoid (SREA) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRMF (SMCF, SA3)
Turns TRAC solenoid (SREC) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRMR (SMCR, STR)
Turns TRAC solenoid (STR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SFRR & SFRH
Turns ABS solenoid (SFRR and SFRH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SFLR & SFLH
Turns ABS solenoid (SFLR and SFLH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRH & SRR
Turns ABS solenoid (SRRH and SRRR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRLR & SRLH
Turns ABS solenoid (SRLR and SRLH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SFRH & SFLH
Turns ABS solenoid (SFRH and SFLH) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRCF & SRCR
Turns TRAC solenoid (SMCF and SREA) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
SRMF & SRMR
Turns TRAC solenoid (SREC and STR) ON / OFF
Operation sound of solenoid (clicking sound) can be heard
ABS WARN LIGHT
Turns ABS warning light ON / OFF
Observe combination meter
VSC WARN LIGHT
Turns VSC TRAC warning light ON / OFF
Observe combination meter
VSC / TRC OFF IND
Turns VSC OFF indicator light ON / OFF
Observe combination meter
SLIP INDI LIGHT
Turn SLIP indicator light ON / OFF
Observe combination meter
BRAKE WRN LIGHT
Turns BRAKE warning light ON / OFF
Observe combination meter
VSC / BR WARN BUZ
Turns skid control buzzer ON / OFF
Buzzer can be heard
H/B MOT RELAY
Turns H/B motor relay ON / OFF
Operation sound of motor can be heard
STOP LIGHT RELAY
Turns stop light operation relay ON / OFF
Observe rear combination light
(Does not come on for 5 sec. or more